И как теперь stm’щики буду презрительно называть ардуинщиков, если те на stm32 пересели?!
Они убили Кенни! Сволочи!
https://dronebotworkshop.com/giga/#Arduino_GIGA_R1_WiFi
Arduino GIGA Specifications
Here is an outline of the specifications of the Arduino GIGA:
Microcontroller
The Arduino GIGA is based on a STM32H747XIH6 Microcontroller. This microcontroller has two cores:
32-bit Arm® Cortex®-M7 core with double-precision FPU and L1 cache up to 480 MHz
32-bit Arm® 32-bit Cortex®-M4 core with FPU up to 240 MHz
The STM32H747XIH6 includes a full set of DSP instructions and a Memory Protection Unit (MPU).
WiFi & Bluetooth
The Arduino GIGA uses a Murata® 1DX Wi-Fi/Bluetooth Module with the following capabilities:
Wi-Fi 802.11b/g/n 65 Mbps
Bluetooth Low Energy (version 5.X via Cordio stack, version 4.2 via Arduino Stack)
Memory
There are three memory storage devices on the Arduino GIGA, with a total of five memory areas.
STM32H747XI – 2MB Flash & 1 MB RAM
AT25SF128A-MHB-T – 16 MB NOR Flash
AS4C4M16SA – 8 MB SDRAM
Input/Output
The Arduino GIGA has a wide variety of I/O pins:
Digital I/O Pins: 76
Analog input pins: 12
PWM pins: 12
Analog output pins (DAC0/DAC1): 2
USB Host: USB 2.0 A
USB Peripheral: USB-C®
Logic level: 3.3V
VRTC: To power the RTC while the board is off
OFF pin: To turn off the board
Communication
There are also many communications options on the GIGA:
4x UART
3x I2C
2x SPI
1x CAN (an external transceiver is required)
USB Ports
There are two USB connectors on the Arduino GIGA:
USB-A – USB Host for keyboards, mice, and USB mass storage devices.
USB-C – Programming and HID (emulates mice and keyboards)
