История изменений

Исправление roman77, 18.02.14 21:52 (текущая версия) :

Если сделать так:

auto br0
        iface br0 inet static
        address 192.168.1.101
        netmask 255.255.255.0
        gateway 192.168.1.1
        bridge_ports eth1
        bridge_stp off
        bridge_fd 0
        bridge_maxwait 0
        pre-up ifconfig eth1 up
        post-down ifconfig eth1 down

То картина такая:

[    3.552770] IPv6: ADDRCONF(NETDEV_UP): eth1: link is not ready
[    3.559519] Bridge firewalling registered
[    3.560857] device eth1 entered promiscuous mode
[    3.562875] IPv6: ADDRCONF(NETDEV_UP): br0: link is not ready
[    5.232911] e1000e: eth1 NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[    5.234016] e1000e 0000:00:19.0 eth1: 10/100 speed: disabling TSO
[    5.235144] IPv6: ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[    5.236195] br0: port 1(eth1) entered forwarding state
[    5.237207] br0: port 1(eth1) entered forwarding state
[    5.238232] IPv6: ADDRCONF(NETDEV_CHANGE): br0: link becomes ready
[    5.343791] e1000e: eth1 NIC Link is Down
[    6.236662] br0: port 1(eth1) entered disabled state
[    7.087937] e1000e: eth1 NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[    7.088909] e1000e 0000:00:19.0 eth1: 10/100 speed: disabling TSO
[    7.089921] br0: port 1(eth1) entered forwarding state
[    7.090182] random: nonblocking pool is initialized
[    7.091763] br0: port 1(eth1) entered forwarding state
[   13.651306] ip_tables: (C) 2000-2006 Netfilter Core Team
[   13.654165] nf_conntrack version 0.5.0 (16384 buckets, 65536 max)
[   13.676117] zram: module is from the staging directory, the quality is unknown, you have been warned.
[   13.679894] zram: Created 8 device(s) ...
[   13.681216] r8169 0000:03:00.0: firmware: direct-loading firmware rtl_nic/rtl8168e-2.fw
[   13.753801] Adding 1018108k swap on /dev/zram0.  Priority:100 extents:1 across:1018108k SS
[   13.755268] Adding 1018108k swap on /dev/zram1.  Priority:100 extents:1 across:1018108k SS
[   13.756455] Adding 1018108k swap on /dev/zram2.  Priority:100 extents:1 across:1018108k SS
[   13.757958] Adding 1018108k swap on /dev/zram3.  Priority:100 extents:1 across:1018108k SS
[   13.759057] Adding 1018108k swap on /dev/zram4.  Priority:100 extents:1 across:1018108k SS
[   13.759546] Adding 1018108k swap on /dev/zram5.  Priority:100 extents:1 across:1018108k SS
[   13.760285] Adding 1018108k swap on /dev/zram6.  Priority:100 extents:1 across:1018108k SS
[   13.760831] Adding 1018108k swap on /dev/zram7.  Priority:100 extents:1 across:1018108k SS
[   13.819463] r8169 0000:03:00.0 eth0: link down
[   13.820170] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready

Немного, да лучше.

А так оба интерфейса не поднимаются:

auto eth1
        iface eth1 inet manual
        pre-up ifconfig br0 up
        post-down ifconfig br0 down

        iface br0 inet static
        address 192.168.1.101
        netmask 255.255.255.0
        gateway 192.168.1.1
        bridge_ports eth1
        bridge_stp off
        bridge_fd 0
        bridge_maxwait 0

Что не удивительно.

Исправление roman77, 18.02.14 21:51:

Если сделать так:

auto br0
        iface br0 inet static
        address 192.168.1.101
        netmask 255.255.255.0
        gateway 192.168.1.1
        bridge_ports eth1
        bridge_stp off
        bridge_fd 0
        bridge_maxwait 0
        pre-up ifconfig eth1 up
        post-down ifconfig eth1 down

То картина такая:

[    3.552770] IPv6: ADDRCONF(NETDEV_UP): eth1: link is not ready
[    3.559519] Bridge firewalling registered
[    3.560857] device eth1 entered promiscuous mode
[    3.562875] IPv6: ADDRCONF(NETDEV_UP): br0: link is not ready
[    5.232911] e1000e: eth1 NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[    5.234016] e1000e 0000:00:19.0 eth1: 10/100 speed: disabling TSO
[    5.235144] IPv6: ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[    5.236195] br0: port 1(eth1) entered forwarding state
[    5.237207] br0: port 1(eth1) entered forwarding state
[    5.238232] IPv6: ADDRCONF(NETDEV_CHANGE): br0: link becomes ready
[    5.343791] e1000e: eth1 NIC Link is Down
[    6.236662] br0: port 1(eth1) entered disabled state
[    7.087937] e1000e: eth1 NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[    7.088909] e1000e 0000:00:19.0 eth1: 10/100 speed: disabling TSO
[    7.089921] br0: port 1(eth1) entered forwarding state
[    7.090182] random: nonblocking pool is initialized
[    7.091763] br0: port 1(eth1) entered forwarding state
[   13.651306] ip_tables: (C) 2000-2006 Netfilter Core Team
[   13.654165] nf_conntrack version 0.5.0 (16384 buckets, 65536 max)
[   13.676117] zram: module is from the staging directory, the quality is unknown, you have been warned.
[   13.679894] zram: Created 8 device(s) ...
[   13.681216] r8169 0000:03:00.0: firmware: direct-loading firmware rtl_nic/rtl8168e-2.fw
[   13.753801] Adding 1018108k swap on /dev/zram0.  Priority:100 extents:1 across:1018108k SS
[   13.755268] Adding 1018108k swap on /dev/zram1.  Priority:100 extents:1 across:1018108k SS
[   13.756455] Adding 1018108k swap on /dev/zram2.  Priority:100 extents:1 across:1018108k SS
[   13.757958] Adding 1018108k swap on /dev/zram3.  Priority:100 extents:1 across:1018108k SS
[   13.759057] Adding 1018108k swap on /dev/zram4.  Priority:100 extents:1 across:1018108k SS
[   13.759546] Adding 1018108k swap on /dev/zram5.  Priority:100 extents:1 across:1018108k SS
[   13.760285] Adding 1018108k swap on /dev/zram6.  Priority:100 extents:1 across:1018108k SS
[   13.760831] Adding 1018108k swap on /dev/zram7.  Priority:100 extents:1 across:1018108k SS
[   13.819463] r8169 0000:03:00.0 eth0: link down
[   13.820170] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready

Немного, да лучше.

А так оба интерфейса не поднимаются:

auto eth1
        iface eth1 inet manual
        pre-up ifconfig br0 up
        post-down ifconfig br0 down

        iface br0 inet static
        address 192.168.1.101
        netmask 255.255.255.0
        gateway 192.168.1.1
        bridge_ports eth1
        bridge_stp off
        bridge_fd 0
        bridge_maxwait 0

Исходная версия roman77, 18.02.14 21:49:

Если сделать так:

auto br0
        iface br0 inet static
        address 192.168.1.101
        netmask 255.255.255.0
        gateway 192.168.1.1
        bridge_ports eth1
        bridge_stp off
        bridge_fd 0
        bridge_maxwait 0
        pre-up ifconfig eth1 up
        post-down ifconfig eth1 down

То картина такая:

[    3.552770] IPv6: ADDRCONF(NETDEV_UP): eth1: link is not ready
[    3.559519] Bridge firewalling registered
[    3.560857] device eth1 entered promiscuous mode
[    3.562875] IPv6: ADDRCONF(NETDEV_UP): br0: link is not ready
[    5.232911] e1000e: eth1 NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[    5.234016] e1000e 0000:00:19.0 eth1: 10/100 speed: disabling TSO
[    5.235144] IPv6: ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[    5.236195] br0: port 1(eth1) entered forwarding state
[    5.237207] br0: port 1(eth1) entered forwarding state
[    5.238232] IPv6: ADDRCONF(NETDEV_CHANGE): br0: link becomes ready
[    5.343791] e1000e: eth1 NIC Link is Down
[    6.236662] br0: port 1(eth1) entered disabled state
[    7.087937] e1000e: eth1 NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[    7.088909] e1000e 0000:00:19.0 eth1: 10/100 speed: disabling TSO
[    7.089921] br0: port 1(eth1) entered forwarding state
[    7.090182] random: nonblocking pool is initialized
[    7.091763] br0: port 1(eth1) entered forwarding state
[   13.651306] ip_tables: (C) 2000-2006 Netfilter Core Team
[   13.654165] nf_conntrack version 0.5.0 (16384 buckets, 65536 max)
[   13.676117] zram: module is from the staging directory, the quality is unknown, you have been warned.
[   13.679894] zram: Created 8 device(s) ...
[   13.681216] r8169 0000:03:00.0: firmware: direct-loading firmware rtl_nic/rtl8168e-2.fw
[   13.753801] Adding 1018108k swap on /dev/zram0.  Priority:100 extents:1 across:1018108k SS
[   13.755268] Adding 1018108k swap on /dev/zram1.  Priority:100 extents:1 across:1018108k SS
[   13.756455] Adding 1018108k swap on /dev/zram2.  Priority:100 extents:1 across:1018108k SS
[   13.757958] Adding 1018108k swap on /dev/zram3.  Priority:100 extents:1 across:1018108k SS
[   13.759057] Adding 1018108k swap on /dev/zram4.  Priority:100 extents:1 across:1018108k SS
[   13.759546] Adding 1018108k swap on /dev/zram5.  Priority:100 extents:1 across:1018108k SS
[   13.760285] Adding 1018108k swap on /dev/zram6.  Priority:100 extents:1 across:1018108k SS
[   13.760831] Adding 1018108k swap on /dev/zram7.  Priority:100 extents:1 across:1018108k SS
[   13.819463] r8169 0000:03:00.0 eth0: link down
[   13.820170] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready

А так оба интерфейса не поднимаются:

auto eth1
        iface eth1 inet manual
        pre-up ifconfig br0 up
        post-down ifconfig br0 down

        iface br0 inet static
        address 192.168.1.101
        netmask 255.255.255.0
        gateway 192.168.1.1
        bridge_ports eth1
        bridge_stp off
        bridge_fd 0
        bridge_maxwait 0