ось opensuse 12.2 (3.4.6-2.10)
уже не в первый раз пытаюсь сделать раздату инета по wifi
поставил из репозита hostapd
собран он оказался без драйвером nl80211
удалил и собрал из исходников
в конфиге уже была раскоменчина строка CONFIG_DRIVER_NL80211=y
но при запуске кричит
Configuration file: hostapd.conf
Failed to update rate sets in kernel module
Could not connect to kernel driver.
Using interface wlan0 with hwaddr dc:a9:71:8b:a5:38 and ssid 'test'
Failed to set beacon parameters
дибаг
hostapd hostapd.conf -dd
random: Trying to read entropy from /dev/random
Configuration file: hostapd.conf
nl80211: interface wlan0 in phy phy0
rfkill: initial event: idx=0 type=1 op=0 soft=0 hard=0
nl80211: Using driver-based off-channel TX
nl80211: Register frame command failed (type=208): ret=-114 (Operation already in progress)
nl80211: Register frame match - hexdump(len=1): 06
nl80211: Failed to register Action frame processing - ignore for now
nl80211: Add own interface ifindex 3
nl80211: Set mode ifindex 3 iftype 3 (AP)
nl80211: Failed to set interface 3 to mode 3: -95 (Operation not supported)
nl80211: Interface already in requested mode - ignore error
nl80211: Create interface iftype 6 (MONITOR)
Failed to create interface mon.wlan0: -23 (Too many open files in system)
Try to remove and re-create mon.wlan0
nl80211: Remove interface ifindex=10
nl80211: Create interface iftype 6 (MONITOR)
nl80211: New interface mon.wlan0 created: ifindex=11
nl80211: Add own interface ifindex 11
BSS count 1, BSSID mask 00:00:00:00:00:00 (0 bits)
nl80211: Regulatory information - country=00
nl80211: 2402-2472 @ 40 MHz
nl80211: 2457-2482 @ 20 MHz
nl80211: 2474-2494 @ 20 MHz
nl80211: 5170-5250 @ 40 MHz
nl80211: 5735-5835 @ 40 MHz
nl80211: Added 802.11b mode based on 802.11g information
Allowed channel: mode=1 chan=1 freq=2412 MHz max_tx_power=15 dBm
Allowed channel: mode=1 chan=2 freq=2417 MHz max_tx_power=15 dBm
Allowed channel: mode=1 chan=3 freq=2422 MHz max_tx_power=15 dBm
Allowed channel: mode=1 chan=4 freq=2427 MHz max_tx_power=15 dBm
Allowed channel: mode=1 chan=5 freq=2432 MHz max_tx_power=15 dBm
Allowed channel: mode=1 chan=6 freq=2437 MHz max_tx_power=15 dBm
Allowed channel: mode=1 chan=7 freq=2442 MHz max_tx_power=15 dBm
Allowed channel: mode=1 chan=8 freq=2447 MHz max_tx_power=15 dBm
Allowed channel: mode=1 chan=9 freq=2452 MHz max_tx_power=15 dBm
Allowed channel: mode=1 chan=10 freq=2457 MHz max_tx_power=15 dBm
Allowed channel: mode=1 chan=11 freq=2462 MHz max_tx_power=15 dBm
Allowed channel: mode=0 chan=1 freq=2412 MHz max_tx_power=15 dBm
Allowed channel: mode=0 chan=2 freq=2417 MHz max_tx_power=15 dBm
Allowed channel: mode=0 chan=3 freq=2422 MHz max_tx_power=15 dBm
Allowed channel: mode=0 chan=4 freq=2427 MHz max_tx_power=15 dBm
Allowed channel: mode=0 chan=5 freq=2432 MHz max_tx_power=15 dBm
Allowed channel: mode=0 chan=6 freq=2437 MHz max_tx_power=15 dBm
Allowed channel: mode=0 chan=7 freq=2442 MHz max_tx_power=15 dBm
Allowed channel: mode=0 chan=8 freq=2447 MHz max_tx_power=15 dBm
Allowed channel: mode=0 chan=9 freq=2452 MHz max_tx_power=15 dBm
Allowed channel: mode=0 chan=10 freq=2457 MHz max_tx_power=15 dBm
Allowed channel: mode=0 chan=11 freq=2462 MHz max_tx_power=15 dBm
Completing interface initialization
Mode: IEEE 802.11b Channel: 1 Frequency: 2412 MHz
nl80211: Set freq 2412 (ht_enabled=0 sec_channel_offset=0)
Failed to update rate sets in kernel module
RATE[0] rate=10 flags=0x1
RATE[1] rate=20 flags=0x1
RATE[2] rate=55 flags=0x0
RATE[3] rate=110 flags=0x0
Flushing old station entries
Could not connect to kernel driver.
Deauthenticate all stations
wpa_driver_nl80211_set_key: ifindex=3 alg=0 addr=(nil) key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_nl80211_set_key: ifindex=3 alg=0 addr=(nil) key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_nl80211_set_key: ifindex=3 alg=0 addr=(nil) key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_nl80211_set_key: ifindex=3 alg=0 addr=(nil) key_idx=3 set_tx=0 seq_len=0 key_len=0
Using interface wlan0 with hwaddr dc:a9:71:8b:a5:38 and ssid 'reptily'
nl80211: Set beacon (beacon_set=0)
nl80211: Beacon set failed: -95 (Operation not supported)
Failed to set beacon parameters
wpa_driver_nl80211_set_operstate: operstate 0->1 (UP)
netlink: Operstate: linkmode=-1, operstate=6
Failed to set TX queue parameters for queue 0.
Failed to set TX queue parameters for queue 1.
Failed to set TX queue parameters for queue 2.
Failed to set TX queue parameters for queue 3.
wlan0: Setup of interface done.
random: Got 20/20 bytes from /dev/random
RTM_NEWLINK: operstate=1 ifi_flags=0x1002 ()
nl80211: Ignore interface down event since interface wlan0 is up
nl80211: Ignore event for foreign ifindex 10
nl80211: Ignore dellink event for foreign ifindex 10
RTM_NEWLINK: operstate=1 ifi_flags=0x1002 ()
nl80211: Ignore interface down event since interface mon.wlan0 is up
RTM_NEWLINK: operstate=1 ifi_flags=0x11043 ([UP][RUNNING][LOWER_UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'mon.wlan0' added
Unknown event 5
RTM_NEWLINK: operstate=1 ifi_flags=0x1003 ([UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'wlan0' added
nl80211: if_removed already cleared - ignore event
mgmt::deauth cb
RTM_NEWLINK: operstate=1 ifi_flags=0x1002 ()
nl80211: Ignore interface down event since interface mon.wlan0 is up
recv: Network is down
конфиг
interface=wlan0
driver=nl80211
ssid=reptily
channel=1
все принцапи понятно но незнаю что делать дальше
дятька гугал не помагает
сетевуха умеет работать как точка доступа на дас виндовсе проверял
да и на само коробке это заявлено
hostapd, opensuse, wi-fi
