Долгая инициализация сети при загрузке (Debian 7.8)
Столкнулся с такой проблемой. Имеется шлюз на Debian 7.8, на котором 5 сетевых интерфейсов: eth0 - смотрит в инет (статика), eth1-4 - локальные. Установлены squid3, dhcp, bind9, настроены iptables. Работает все нормально до тех пор, пока внешняя eth0 сама по себе не отваливается, в логе пишется следующее:
Jan 30 15:14:44 avahi-daemon[3420]: Interface eth0.IPv6 no longer relevant for mDNS.
Jan 30 15:14:44 avahi-daemon[3420]: Leaving mDNS multicast group on interface eth0.IPv6 with address fe80::76d4:35ff:fe95:3182.
Jan 30 15:14:44 NetworkManager[3455]: <info> (eth0): carrier now OFF (device state 10)
Jan 30 15:14:44 avahi-daemon[3420]: Interface eth0.IPv4 no longer relevant for mDNS.
Jan 30 15:14:44 avahi-daemon[3420]: Leaving mDNS multicast group on interface eth0.IPv4 with address <<ext_ip>>.
Jan 30 15:14:44 avahi-daemon[3420]: Withdrawing address record for fe80::76d4:35ff:fe95:3182 on eth0.
Jan 30 15:14:44 avahi-daemon[3420]: Withdrawing address record for <<ext_ip>> on eth0.
..........
Jan 30 15:14:49 kernel: [77356.396068] r8169 0000:03:00.0 eth0: link down
Jan 30 15:14:49 kernel: [77356.396121] r8169 0000:03:00.0 eth0: link down
Jan 30 15:14:49 kernel: [77356.396204] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
Jan 30 15:14:50 kernel: [77358.098233] r8169 0000:03:00.0 eth0: link up
Jan 30 15:14:50 kernel: [77358.098244] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
Также при загрузке очень долго инициализируется сеть; вот кусок из dmesg
[ 6.890556] r8169 0000:03:00.0 eth0: link down
[ 6.893902] r8169 0000:03:00.0 eth0: link down
[ 6.894017] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 9.219144] r8169 0000:03:00.0 eth0: link up
[ 9.221172] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[ 19.234930] r8169 0000:05:02.0 eth1: link down
[ 19.236756] IPv6: ADDRCONF(NETDEV_UP): eth1: link is not ready
[ 43.358767] 8139too 0000:05:01.0 eth2: link down
[ 43.360036] IPv6: ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 55.419459] 8139too 0000:05:00.0 eth3: link down
[ 55.420918] IPv6: ADDRCONF(NETDEV_UP): eth3: link is not ready
[ 67.621163] r8169 0000:02:00.0 eth4: link down
[ 67.624001] IPv6: ADDRCONF(NETDEV_UP): eth4: link is not ready
[ 79.912821] RPC: Registered named UNIX socket transport module.
[ 79.913712] RPC: Registered udp transport module.
[ 79.914571] RPC: Registered tcp transport module.
[ 79.915436] RPC: Registered tcp NFSv4.1 backchannel transport module.
Пробовал отключить IPv6 auto configuration в /etc/sysctl.conf:
net.ipv6.conf.default.autoconf = 0
net.ipv6.conf.default.accept_ra = 0
net.ipv6.conf.all.autoconf = 0
net.ipv6.conf.all.accept_ra = 0
net.ipv6.conf.eth0.autoconf = 0
net.ipv6.conf.eth0.accept_ra = 0
net.ipv6.conf.eth1.autoconf = 0
net.ipv6.conf.eth1.accept_ra = 0
net.ipv6.conf.eth2.autoconf = 0
net.ipv6.conf.eth2.accept_ra = 0
net.ipv6.conf.eth3.autoconf = 0
net.ipv6.conf.eth3.accept_ra = 0
net.ipv6.conf.eth4.autoconf = 0
net.ipv6.conf.eth4.accept_ra = 0
/if-up.d:
--avahi-daemon
--bind9
--ethtool
--mountnfs
--openssh-server
--upstart
В какую сторону копать,подскажите??
