Tx\Rx bandwidth limit на 2950-той Сиське "( . )( . )" ?

conf t
int fa0/24
traffic-shape # хз не помню
rate-limit # аналогично
end

cisco(config)#interface fastEthernet 0/24
cisco(config-if)#?
Interface configuration commands:
  arp                 Set arp type (arpa, probe, snap) or timeout
  auto                Configure Automation
  bandwidth           Set bandwidth informational parameter
  carrier-delay       Specify delay for interface transitions
  cdp                 CDP interface subcommands
  channel-group       Etherchannel/port bundling configuration
  channel-protocol    Select the channel protocol (LACP, PAgP)
  default             Set a command to its defaults
  delay               Specify interface throughput delay
  description         Interface specific description
  dot1x               Interface Config Commands for 802.1x
  duplex              Configure duplex operation.
  exit                Exit from interface configuration mode
  fair-queue          Enable Fair Queuing on an Interface
  help                Description of the interactive help system
  hold-queue          Set hold queue depth
  ip                  Interface Internet Protocol config commands
  keepalive           Enable keepalive
  lacp                LACP interface subcommands
  load-interval       Specify interval for load calculation for an interface
  logging             Configure logging for interface
  mac                 MAC interface commands
  mac-address         Manually set interface MAC address
  mls                 mls interface commands
  mvr                 MVR per port configuration
  no                  Negate a command or set its defaults
  pagp                PAgP interface subcommands
  random-detect       Enable Weighted Random Early Detection (WRED) on an
                      Interface
  rmon                Configure Remote Monitoring on an interface
  service-policy      Configure QoS Service Policy
  shutdown            Shutdown the selected interface
  snmp                Modify SNMP interface parameters
  spanning-tree       Spanning Tree Subsystem
  speed               Configure speed operation.
  storm-control       storm configuration
  switchport          Set switching mode characteristics
  timeout             Define timeout values for this interface
  transmit-interface  Assign a transmit interface to a receive-only interface
  tx-ring-limit       Configure PA level transmit ring limit
  udld                Configure UDLD enabled or disabled and ignore global UDLD setting