gprs megafon : timeout sending Config-Request

Вот какая ошибка возникает при коннекте
Using interface ppp0
Connect: ppp0 <--> /dev/ttyUSB0
sent [LCP ConfReq id=0x1 <magic 0x53e9b08b> <pcomp> <accomp>]
sent [LCP ConfReq id=0x1 <magic 0x53e9b08b> <pcomp> <accomp>]
sent [LCP ConfReq id=0x1 <magic 0x53e9b08b> <pcomp> <accomp>]
sent [LCP ConfReq id=0x1 <magic 0x53e9b08b> <pcomp> <accomp>]
sent [LCP ConfReq id=0x1 <magic 0x53e9b08b> <pcomp> <accomp>]
sent [LCP ConfReq id=0x1 <magic 0x53e9b08b> <pcomp> <accomp>]
sent [LCP ConfReq id=0x1 <magic 0x53e9b08b> <pcomp> <accomp>]
sent [LCP ConfReq id=0x1 <magic 0x53e9b08b> <pcomp> <accomp>]
sent [LCP ConfReq id=0x1 <magic 0x53e9b08b> <pcomp> <accomp>]
sent [LCP ConfReq id=0x1 <magic 0x53e9b08b> <pcomp> <accomp>]
LCP: timeout sending Config-Request
Вот мои конфиги, ткните где не так, в начале юзал без строчки user
 "user", но без нее не вышло, решил добавить, но ниче не измнилось,
 такое ощущение что не тот конфиг читает.
#cat /etc/ppp/peers/gprs
# You usually need this if there is no PAP authentication
noauth
# The chat script (be sure to edit that file, too!)
connect "/usr/sbin/chat -v -f /etc/ppp/peers/chat-gprs"
# Set up routing to go through this PPP link
defaultroute
/dev/ttyUSB0
57600
# Reconnect on disconnect
#persist
# Be extra verbose
debug
# You may need these
passive
noipdefault
noproxyarp
ipcp-accept-local
ipcp-accept-remote
ipcp-restart 2
ipcp-max-configure 20
ipcp-max-failure 20
#asyncmap 0xa0000
default-asyncmap
novj
nodeflate
nobsdcomp
# Use remote DNS
usepeerdns
# With GPRS, authentication is normally done  automatically
# via your cellphone number, so leave login name empty
user "user"


#cat /etc/ppp/peers/chat-gprs
TIMEOUT 5
ECHO ON
ABORT '\nBUSY\r'
ABORT '\nERROR\r'
ABORT '\nNO ANSWER\r'
ABORT '\nNO CARRIER\r'
ABORT '\nNO DIALTONE\r'
ABORT '\nRINGING\r\n\r\nRINGING\r'
'' \rAT
TIMEOUT 12
OK ATE1
OK              'AT+CGDCONT=1,"IP","internet"' 
OK              ATD*99***1#

#cat /etc/ppp/peers/pap-secret
user * pass
#cat /etc/ppp/peers/chap-secret
user * pass