ARM. Toradex Colibri PXA320. Ядро не загружается.

Еще раз здравствуйте, все.
Продолжаю работать над установкой Линукс на плату Toradex Colibri PXA320.
Теперь проблема вот в чем. Загрузка ядра, как я думаю, заканчивается на стадии инициализации COM-порта, а именно на строке: 'pxa2xx-uart.0: ttyS0 at MMIO 0x40100000 (irq = 22) is a FFUART'. Дальше загрузка не идет.
В чем проблема? Ниже привожу полный трейс ядра и конфиг:

trace:
Uncompressing Linux.......................................................................... ...........................
... done, booting the kernel.
<5>[ 0.000000] Linux version 2.6.31 (den@localhost) (gcc version 4.2.4) #15 Wed Sep 30 14:09:12 MSD 2009
<4>[ 0.000000] CPU: XScale-V3 based processor [69056826] revision 6 (ARMv5TE), cr=0000397f
<4>[ 0.000000] CPU: VIVT data cache, VIVT instruction cache
<4>[ 0.000000] Machine: Toradex Colibri PXA320
<4>[ 0.000000] Memory policy: ECC disabled, Data cache writeback
<7>[ 0.000000] On node 0 totalpages: 32768
<7>[ 0.000000] free_area_init_node: node 0, pgdat c0329dbc, node_mem_map c0360000
<7>[ 0.000000] Normal zone: 256 pages used for memmap
<7>[ 0.000000] Normal zone: 0 pages reserved
<7>[ 0.000000] Normal zone: 32512 pages, LIFO batch:7
<6>[ 0.000000] RO Mode clock: 60.00MHz (inactive)
<6>[ 0.000000] Run Mode clock: 403.00MHz (*31)
<6>[ 0.000000] Turbo Mode clock: 806.00MHz (*2, active)
<6>[ 0.000000] HSIO bus clock: 208.00MHz
<4>[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32512
<5>[ 0.000000] Kernel command line: console ttyS0,9600n8
<4>[ 0.000000] PID hash table entries: 512 (order: 9, 2048 bytes)
<6>[ 0.000000] Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
<6>[ 0.000000] Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
<6>[ 0.000000] Memory: 128MB = 128MB total
<5>[ 0.000000] Memory: 126336KB available (2924K code, 368K data, 116K init, 0K highmem)
<6>[ 0.000000] SLUB: Genslabs=11, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
<6>[ 0.000000] NR_IRQS:192
<4>[ 3.006805] Console: colour dummy device 80x30
<6>[ 3.063213] console [tty0] enabled
<6>[ 3.107296] Calibrating delay loop... 804.45 BogoMIPS (lpj=4022272)
<4>[ 3.405741] Mount-cache hash table entries: 512
<6>[ 3.463613] CPU: Testing write buffer coherency: failed, enabling work-around
<6>[ 3.555958] XScale3 L2 cache enabled.
<6>[ 3.603696] NET: Registered protocol family 16
<6>[ 3.662403] colibri_pxa3xx_init_eth(): no valid serial boot tag found, taking MAC from device
<4>[ 3.775325] bio: create slab <bio-0> at 0
<5>[ 3.827660] SCSI subsystem initialized
<6>[ 3.876026] usbcore: registered new interface driver usbfs
<6>[ 3.945179] usbcore: registered new interface driver hub
<6>[ 4.012870] usbcore: registered new device driver usb
<6>[ 4.078994] NET: Registered protocol family 2
<6>[ 4.134462] IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
<6>[ 4.220330] TCP established hash table entries: 4096 (order: 3, 32768 bytes)
<6>[ 4.308182] TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
<6>[ 4.388721] TCP: Hash tables configured (established 4096 bind 4096)
<6>[ 4.468112] TCP reno registered
<6>[ 4.508956] NET: Registered protocol family 1
<4>[ 4.564843] NetWinder Floating Point Emulator V0.97 (double precision)
<6>[ 4.659903] JFFS2 version 2.2. (NAND) AX 2001-2006 Red Hat, Inc.
<6>[ 4.736786] alg: No test for stdrng (krng)
<6>[ 4.789226] io scheduler noop registered
<6>[ 4.839472] io scheduler anticipatory registered
<6>[ 4.898074] io scheduler deadline registered
<6>[ 4.952603] io scheduler cfq registered (default)
<4>[ 5.018936] Console: switching to colour frame buffer device 60x34
<6>[ 5.274240] pxa2xx-uart.0: ttyS0 at MMIO 0x40100000 (irq = 22) is a FFUART

ВСЕ!!! Дальше не грузится, на экран ничего не выводится...