Имеется шлюз на свежеустановленном Debian stable: eth0 - провайдер (ethernet, белый ip), eth1 - внутренняя сеть. канал 125/125 Мбит, однако speedtest у пользователей показывает не больше 45 мбит. Шейперов никаких нет, лишних правил в iptables тоже. В это же время с сервера speedtest показывает стабильно 125/125 Мбит. В чем может быть проблема, подскажите в какую сторону копать || по какому запросу идти в гугл? Проблемы с eth1, я так полагаю?
ifconfig:
eth0 Link encap:Ethernet HWaddr *:*:*:*:*:*
inet addr:*.*.*.* Bcast:*.*.*.* Mask:*.*.*.*
inet6 addr: fe80::96de:80ff:fe6b:d255/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:42253960 errors:0 dropped:0 overruns:0 frame:0
TX packets:33768221 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:37437383219 (34.8 GiB) TX bytes:14956391525 (13.9 GiB)
Interrupt:20 Memory:f0500000-f0520000
eth1 Link encap:Ethernet HWaddr *:*:*:*:*:*
inet addr:192.168.1.1 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::cad3:a3ff:fe83:ced3/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:33906032 errors:0 dropped:0 overruns:0 frame:0
TX packets:38023937 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:14416444324 (13.4 GiB) TX bytes:36896172667 (34.3 GiB)
Interrupt:19 Base address:0xe000
ethtool:
Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 2
Transceiver: internal
Auto-negotiation: on
MDI-X: on
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000007 (7)
drv probe link
Link detected: yes
Settings for eth1:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: Symmetric Receive-only
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
MDI-X: Unknown
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000033 (51)
drv probe ifdown ifup
Link detected: yes
lspci | grep Ethernet:
00:19.0 Ethernet controller: Intel Corporation Ethernet Connection I217-V (rev 04)
03:00.0 Ethernet controller: D-Link System Inc DGE-528T Gigabit Ethernet Adapter (rev 10)
