Обычные симптомы… ошибки на ФС, причем как на Windows, так и на Linux (да, стоит дуалбут).
Вот решил SMART после всего глянуть, а там вот такое:
root@hp15:~# smartctl -s on -a /dev/sda
smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.10.0-11-amd64] (local build)
Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Device Model: Samsung SSD 870 EVO 500GB
Serial Number: S5Y1NJ1R156610N
LU WWN Device Id: 5 002538 f3119ff18
Firmware Version: SVT01B6Q
User Capacity: 500 107 862 016 bytes [500 GB]
Sector Size: 512 bytes logical/physical
Rotation Rate: Solid State Device
Form Factor: 2.5 inches
TRIM Command: Available, deterministic, zeroed
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: ACS-4 T13/BSR INCITS 529 revision 5
SATA Version is: SATA 3.3, 6.0 Gb/s (current: 6.0 Gb/s)
Local Time is: Sun Feb 6 20:25:41 2022 MSK
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF ENABLE/DISABLE COMMANDS SECTION ===
SMART Enabled.
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 0) seconds.
Offline data collection
capabilities: (0x53) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
No Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 85) minutes.
SCT capabilities: (0x003d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 1
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
5 Reallocated_Sector_Ct 0x0033 099 099 010 Pre-fail Always - 5
9 Power_On_Hours 0x0032 099 099 000 Old_age Always - 3013
12 Power_Cycle_Count 0x0032 098 098 000 Old_age Always - 1044
177 Wear_Leveling_Count 0x0013 099 099 000 Pre-fail Always - 13
179 Used_Rsvd_Blk_Cnt_Tot 0x0013 099 099 010 Pre-fail Always - 5
181 Program_Fail_Cnt_Total 0x0032 100 100 010 Old_age Always - 0
182 Erase_Fail_Count_Total 0x0032 100 100 010 Old_age Always - 0
183 Runtime_Bad_Block 0x0013 099 099 010 Pre-fail Always - 5
187 Reported_Uncorrect 0x0032 099 099 000 Old_age Always - 524
190 Airflow_Temperature_Cel 0x0032 070 054 000 Old_age Always - 30
195 Hardware_ECC_Recovered 0x001a 199 199 000 Old_age Always - 524
199 UDMA_CRC_Error_Count 0x003e 099 099 000 Old_age Always - 4
235 Unknown_Attribute 0x0012 099 099 000 Old_age Always - 56
241 Total_LBAs_Written 0x0032 099 099 000 Old_age Always - 10636634684
SMART Error Log Version: 1
ATA Error Count: 524 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 524 occurred at disk power-on lifetime: 3013 hours (125 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 07 79 ac 63 e5 Error: UNC 7 sectors at LBA = 0x0563ac79 = 90418297
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 07 79 ac 63 e5 0b 00:33:26.062 READ DMA
2f 00 01 30 06 00 e5 0b 00:33:26.062 READ LOG EXT
2f 00 01 30 00 00 e5 0b 00:33:26.062 READ LOG EXT
2f 00 01 00 00 00 e5 0b 00:33:26.062 READ LOG EXT
2f 00 01 30 08 00 e5 0b 00:33:26.062 READ LOG EXT
Error 523 occurred at disk power-on lifetime: 3013 hours (125 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 01 78 ac 63 e5 Error: UNC 1 sectors at LBA = 0x0563ac78 = 90418296
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 01 78 ac 63 e5 0b 00:33:25.934 READ DMA
2f 00 01 30 06 00 e5 0b 00:33:25.934 READ LOG EXT
2f 00 01 30 00 00 e5 0b 00:33:25.934 READ LOG EXT
2f 00 01 00 00 00 e5 0b 00:33:25.934 READ LOG EXT
2f 00 01 30 08 00 e5 0b 00:33:25.934 READ LOG EXT
Error 522 occurred at disk power-on lifetime: 3013 hours (125 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 06 7a ac 63 e5 Error: UNC 6 sectors at LBA = 0x0563ac7a = 90418298
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 06 7a ac 63 e5 0b 00:33:25.806 READ DMA
2f 00 01 30 06 00 e5 0b 00:33:25.806 READ LOG EXT
2f 00 01 30 00 00 e5 0b 00:33:25.806 READ LOG EXT
2f 00 01 00 00 00 e5 0b 00:33:25.806 READ LOG EXT
2f 00 01 30 08 00 e5 0b 00:33:25.806 READ LOG EXT
Error 521 occurred at disk power-on lifetime: 3013 hours (125 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 01 79 ac 63 e5 Error: UNC 1 sectors at LBA = 0x0563ac79 = 90418297
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 01 79 ac 63 e5 0b 00:33:25.678 READ DMA
2f 00 01 30 06 00 e5 0b 00:33:25.678 READ LOG EXT
2f 00 01 30 00 00 e5 0b 00:33:25.678 READ LOG EXT
2f 00 01 00 00 00 e5 0b 00:33:25.678 READ LOG EXT
2f 00 01 30 08 00 e5 0b 00:33:25.678 READ LOG EXT
Error 520 occurred at disk power-on lifetime: 3013 hours (125 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 01 78 ac 63 e5 Error: UNC 1 sectors at LBA = 0x0563ac78 = 90418296
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 01 78 ac 63 e5 0b 00:33:25.558 READ DMA
2f 00 01 30 06 00 e5 0b 00:33:25.558 READ LOG EXT
2f 00 01 30 00 00 e5 0b 00:33:25.558 READ LOG EXT
2f 00 01 00 00 00 e5 0b 00:33:25.558 READ LOG EXT
2f 00 01 30 08 00 e5 0b 00:33:25.558 READ LOG EXT
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Extended offline Aborted by host 20% 909 -
# 2 Short offline Completed without error 00% 476 -
# 3 Short offline Completed without error 00% 423 -
# 4 Short offline Completed without error 00% 408 -
# 5 Short offline Completed without error 00% 377 -
# 6 Extended offline Aborted by host 50% 362 -
# 7 Short offline Completed without error 00% 224 -
# 8 Short offline Completed without error 00% 209 -
# 9 Short offline Completed without error 00% 207 -
#10 Short offline Completed without error 00% 205 -
#11 Short offline Completed without error 00% 202 -
#12 Short offline Completed without error 00% 176 -
#13 Short offline Completed without error 00% 94 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
256 0 65535 Read_scanning was never started
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
Ну и на сколько всё плохо, как считаете?
