поломалась cava - визуализатор эквалайзера

grep running /proc/asound/Loopback/cable#?

grep running /proc/asound/Loopback/cable#0
  running: 2
grep running /proc/asound/Loopback/cable#1

[input]
method = pipewire

$ cat ~/.config/cava/config  | grep pulse -B4


[input]

# Audio capturing method. Possible methods are: 'pulse', 'alsa', 'fifo', 'sndio' or 'shmem'
# Defaults to 'pulse', 'alsa' or 'fifo', in that order, dependent on what support cava was built with.
#
# All input methods uses the same config variable 'source'
# to define where it should get the audio.
#
# For pulseaudio 'source' will be the source. Default: 'auto', which uses the monitor source of the default sink
# (all pulseaudio sinks(outputs) have 'monitor' sources(inputs) associated with them).
#
# For alsa 'source' will be the capture device.
# For fifo 'source' will be the path to fifo-file.
# For shmem 'source' will be /squeezelite-AA:BB:CC:DD:EE:FF where 'AA:BB:CC:DD:EE:FF' will be squeezelite's MAC address
; method = pulse

fastgunner прокомментировал 2023-08-08 14:56 (UTC)
@untemi
not sure what version of Arch you are on but I'm using garuda and I had to go into the cava/config file and uncomment the source to use pulse with auto. It looks like the new update added a check for pipewire so if you are using that, you will need to tell it to use whatever your audio engine is instead.

untemi прокомментировал 2023-08-07 21:51 (UTC)
Похоже, что сегодняшнее обновление не работает для меня Вывод : 'Модуль ядра Linux "snd_aloop", похоже, не загружен. Может быть, запустить "sudo modprobe snd_aloop".'