В утилите ethtool есть следующие опции:
-e --eeprom-dump
Retrieves and prints an EEPROM dump for the specified network device. When raw is enabled, then it dumps the raw EEPROM data to stdout. The length and offset parameters allow dumping certain portions of the EEPROM. Default is to dump the entire EEPROM.
-E --change-eeprom
If value is specified, changes EEPROM byte for the specified network device. offset and value specify which byte and it's new value. If value is not specified, stdin is read and written to the EEPROM. The length and offset parameters allow writing to certain portions of the EEPROM. Because of the persistent nature of writing to the EEPROM, a device-specific magic key must be specified to prevent the accidental writing to the EEPROM.
-f --flash FILE
Flash firmware image from the specified file to a region on the adapter. By default this will flash all the regions on the adapter.
