[root@localhost ~]# uname -a
Linux localhost.localdomain 3.10.0-693.11.6.v7.x86_64 #1 SMP Fri Jan 5 02:51:24 MST 2018 x86_64 x86_64 x86_64 GNU/Linux
[root@localhost ~]# lspci
00:00.0 Host bridge: Intel Corporation 82945G/GZ/P/PL Memory Controller Hub (rev 02)
00:02.0 VGA compatible controller: Intel Corporation 82945G/GZ Integrated Graphics Controller (rev 02)
00:1b.0 Audio device: Intel Corporation NM10/ICH7 Family High Definition Audio Controller (rev 01)
00:1c.0 PCI bridge: Intel Corporation NM10/ICH7 Family PCI Express Port 1 (rev 01)
00:1c.1 PCI bridge: Intel Corporation NM10/ICH7 Family PCI Express Port 2 (rev 01)
00:1d.0 USB controller: Intel Corporation NM10/ICH7 Family USB UHCI Controller #1 (rev 01)
00:1d.1 USB controller: Intel Corporation NM10/ICH7 Family USB UHCI Controller #2 (rev 01)
00:1d.2 USB controller: Intel Corporation NM10/ICH7 Family USB UHCI Controller #3 (rev 01)
00:1d.3 USB controller: Intel Corporation NM10/ICH7 Family USB UHCI Controller #4 (rev 01)
00:1d.7 USB controller: Intel Corporation NM10/ICH7 Family USB2 EHCI Controller (rev 01)
00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev e1)
00:1f.0 ISA bridge: Intel Corporation 82801GB/GR (ICH7 Family) LPC Interface Bridge (rev 01)
00:1f.2 IDE interface: Intel Corporation NM10/ICH7 Family SATA Controller [IDE mode] (rev 01)
00:1f.3 SMBus: Intel Corporation NM10/ICH7 Family SMBus Controller (rev 01)
02:00.0 Ethernet controller: Marvell Technology Group Ltd. 88E8053 PCI-E Gigabit Ethernet Controller (rev 19)
03:00.0 Ethernet controller: VIA Technologies, Inc. VT6105/VT6106S [Rhine-III] (rev 8b)
03:01.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8100/8101L/8139 PCI Fast Ethernet Adapter (rev 10)
03:07.0 FireWire (IEEE 1394): Texas Instruments TSB43AB23 IEEE-1394a-2000 Controller (PHY/Link)
[root@localhost ~]# ifconfig -a
enp2s0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500
ether 00:16:e6:42:23:bb txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 17
enp3s1: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.100.36 netmask 255.255.255.0 broadcast 192.168.100.255
inet6 fe80::202:44ff:fe0c:b052 prefixlen 64 scopeid 0x20<link>
ether 00:02:44:0c:b0:52 txqueuelen 1000 (Ethernet)
RX packets 4960 bytes 310510 (303.2 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 386 bytes 35249 (34.4 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1 (Local Loopback)
RX packets 239 bytes 512332 (500.3 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 239 bytes 512332 (500.3 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
[root@localhost ~]# lspci -s 02:00.0 -vv
02:00.0 Ethernet controller: Marvell Technology Group Ltd. 88E8053 PCI-E Gigabit Ethernet Controller (rev 19)
Subsystem: Gigabyte Technology Co., Ltd Marvell 88E8053 Gigabit Ethernet Controller (Gigabyte)
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 26
Region 0: Memory at e1000000 (64-bit, non-prefetchable) [size=16K]
Region 2: I/O ports at 9000 [size=256]
[virtual] Expansion ROM at e0000000 [disabled] [size=128K]
Capabilities: [48] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=1 PME-
Capabilities: [50] Vital Product Data
Product Name: Marvell Yukon 88E8053 Gigabit Ethernet Controller
Read-only fields:
[PN] Part number: Yukon 88E8053
[EC] Engineering changes: Rev. 1.9
[MN] Manufacture ID: 4d 61 72 76 65 6c 6c
[SN] Serial number: AbCdEfG4223BB
[CP] Extended capability: 01 10 cc 03
[RV] Reserved: checksum good, 9 byte(s) reserved
Read/write fields:
[RW] Read-write area: 121 byte(s) free
End
Capabilities: [5c] MSI: Enable+ Count=1/2 Maskable- 64bit+
Address: 00000000fee0300c Data: 4142
Capabilities: [e0] Express (v1) Legacy Endpoint, MSI 00
DevCap: MaxPayload 128 bytes, PhantFunc 0, Latency L0s unlimited, L1 unlimited
ExtTag- AttnBtn- AttnInd- PwrInd- RBE- FLReset-
DevCtl: Report errors: Correctable- Non-Fatal- Fatal- Unsupported-
RlxdOrd- ExtTag- PhantFunc- AuxPwr+ NoSnoop-
MaxPayload 128 bytes, MaxReadReq 512 bytes
DevSta: CorrErr+ UncorrErr- FatalErr- UnsuppReq- AuxPwr+ TransPend-
LnkCap: Port #0, Speed 2.5GT/s, Width x1, ASPM L0s, Exit Latency L0s <256ns, L1 unlimited
ClockPM- Surprise- LLActRep- BwNot- ASPMOptComp-
LnkCtl: ASPM Disabled; RCB 128 bytes Disabled- CommClk-
ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt-
LnkSta: Speed 2.5GT/s, Width x1, TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt-
Capabilities: [100 v1] Advanced Error Reporting
UESta: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-
UEMsk: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol-
UESvrt: DLP+ SDES- TLP- FCP+ CmpltTO- CmpltAbrt- UnxCmplt- RxOF+ MalfTLP+ ECRC- UnsupReq- ACSViol-
CESta: RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr-
CEMsk: RxErr- BadTLP- BadDLLP- Rollover- Timeout- NonFatalErr-
AERCap: First Error Pointer: 1f, GenCap- CGenEn- ChkCap- ChkEn-
Kernel driver in use: sky2
Kernel modules: sky2
Обе другие сетевые карты поднимаются без проблем, у этой не хочет в dmesg летит вот это
[ 357.553151] sky2 0000:02:00.0 enp2s0: disabling interface
[ 358.383320] sky2 0000:02:00.0 enp2s0: enabling interface
[ 358.383393] IPv6: ADDRCONF(NETDEV_UP): enp2s0: link is not ready
[ 374.166389] sky2 0000:02:00.0 enp2s0: disabling interface
[ 374.986098] sky2 0000:02:00.0 enp2s0: enabling interface
[ 374.986170] IPv6: ADDRCONF(NETDEV_UP): enp2s0: link is not ready
[ 390.765733] sky2 0000:02:00.0 enp2s0: disabling interface
[ 391.589953] sky2 0000:02:00.0 enp2s0: enabling interface
[ 391.590051] IPv6: ADDRCONF(NETDEV_UP): enp2s0: link is not ready
[ 407.358849] sky2 0000:02:00.0 enp2s0: disabling interface
[ 408.181702] sky2 0000:02:00.0 enp2s0: enabling interface
[ 408.181776] IPv6: ADDRCONF(NETDEV_UP): enp2s0: link is not ready
[ 423.962485] sky2 0000:02:00.0 enp2s0: disabling interface
[ 424.778977] sky2 0000:02:00.0 enp2s0: enabling interface
[ 424.779075] IPv6: ADDRCONF(NETDEV_UP): enp2s0: link is not ready
[ 440.561238] sky2 0000:02:00.0 enp2s0: disabling interface
[ 441.379278] sky2 0000:02:00.0 enp2s0: enabling interface
[ 441.379350] IPv6: ADDRCONF(NETDEV_UP): enp2s0: link is not ready
До этого стоял Kerio Connect (там эта сетевая работает) кабель проверял, менял, тестировал, дело точно не в нем