Я тут уже писал о проблеме с девайсом... Вообщем:
Jun 25 17:16:31 localhost kernel: usb 1-1: new high speed USB device using ehci_hcd and address 8 Jun 25 17:16:32 localhost kernel: usb 1-1: configuration #1 chosen from 1 choice Jun 25 17:16:32 localhost kernel: scsi3 : SCSI emulation for USB Mass Storage devices Jun 25 17:16:32 localhost kernel: usb-storage: device found at 8 Jun 25 17:16:32 localhost kernel: usb-storage: waiting for device to settle before scanning Jun 25 17:16:37 localhost kernel: Vendor: Maxtor 6 Model: L160P0 Rev: BAJ4 Jun 25 17:16:37 localhost kernel: Type: Direct-Access ANSI SCSI revision: 00 Jun 25 17:16:37 localhost kernel: SCSI device sda: 320173056 512-byte hdwr sectors (163929 MB) Jun 25 17:16:37 localhost kernel: sda: Write Protect is off Jun 25 17:16:37 localhost kernel: sda: Mode Sense: 00 14 00 00 Jun 25 17:16:37 localhost kernel: sda: assuming drive cache: write through Jun 25 17:16:37 localhost kernel: SCSI device sda: 320173056 512-byte hdwr sectors (163929 MB) Jun 25 17:16:37 localhost kernel: sda: Write Protect is off Jun 25 17:16:37 localhost kernel: sda: Mode Sense: 00 14 00 00 Jun 25 17:16:37 localhost kernel: sda: assuming drive cache: write through Jun 25 17:16:37 localhost kernel: sda: unknown partition table Jun 25 17:16:37 localhost kernel: sd 3:0:0:0: Attached scsi disk sda Jun 25 17:16:37 localhost kernel: sd 3:0:0:0: Attached scsi generic sg0 type 0 Jun 25 17:16:37 localhost kernel: usb-storage: device scan complete Jun 25 17:16:48 localhost kernel: usb 1-1: USB disconnect, address 8
Это IDE диск подключаемый через USB интерфейс к компу. USB 2.0 . EHCI, OHCI, UHCI поддерживаются, udev работает. Диск дисконектится и после очередного подключения к компу не определяется ВООБЩЕ никак. Ни единой строчки в логах , dmesg тоже молчит. Обычная флешка определяется идеально. Куда рыть??