Господа Линюксойды! Подскажите мне что это:
Пытаюсь записать болванку в k3b, а она зараза не пишется. Вот лог сессии: cdrecord ----------------------- scsidev: '0,0,0' scsibus: 0 target: 0 lun: 0 Linux sg driver version: 3.1.24 Cdrecord 2.01a04 (i686-pc-linux-gnu) Copyright (C) 1995-2002 Jцrg Schilling TOC Type: 1 = CD-ROM Using libscg version 'schily-0.7' Driveropts: 'burnfree' atapi: 1 Device type : Removable CD-ROM Version : 0 Response Format: 1 Vendor_info : 'MITSUMI ' Identifikation : 'CR-48X9TE ' Revision : '1.0C' Device seems to be: Philips CDD-522. Using generic SCSI-3/mmc CD-R driver (mmc_cdr). Driver flags : MMC-2 SWABAUDIO BURNFREE Supported modes: TAO PACKET SAO SAO/R96R RAW/R16 RAW/R96R Drive buf size : 1589248 = 1552 KB FIFO size : 4194304 = 4096 KB Track 01: data 33 MB Total size: 38 MB (03:48.81) = 17161 sectors Lout start: 38 MB (03:50/61) = 17161 sectors Current Secsize: 2048 ATIP info from disk: Indicated writing power: 6 Is not unrestricted Is not erasable Disk sub type: Medium Type C, low Beta category (C-) (6) ATIP start of lead in: -11231 (97:32/19) ATIP start of lead out: 359848 (79:59/73) Disk type: Short strategy type (Phthalocyanine or similar) Manuf. index: 27 Manufacturer: Prodisc Technology Inc. Blocks total: 359848 Blocks current: 359848 Blocks remaining: 342687 Starting to write CD/DVD at speed 4 in real SAO mode for single session. Last chance to quit, starting real write in 2 seconds. 1 seconds. 0 seconds. Operation starts. Waiting for reader process to fill input buffer ... input buffer ready. BURN-Free is OFF. Turning BURN-Free on Performing OPC... Sending CUE sheet... Writing pregap for track 1 at -150 Starting new track at sector: 0 Track 01: 0 of 33 MB written. Track 01: 1 of 33 MB written (fifo 100%) 0.2x. /usr/bin/cdrecord: Input/output error. write_g1: scsi sendcmd: no error CDB: 2A 00 00 00 02 0F 00 00 1F 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 05 00 00 00 00 0A 00 00 00 00 24 00 00 00 Sense Key: 0x5 Illegal Request, Segment 0 Sense Code: 0x24 Qual 0x00 (invalid field in cdb) Fru 0x0 Sense flags: Blk 0 (not valid) cmd finished after 0.003s timeout 200s write track data: error after 1079296 bytes Writing time: 46.750s Average write speed 5.2x. Fixating... Sense Bytes: 70 00 00 00 00 00 00 0A 00 00 00 00 00 00 00 00 00 00 Fixating time: 0.003s /usr/bin/cdrecord: Input/output error. start/stop unit: scsi sendcmd: no error CDB: 1B 00 00 00 02 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 06 00 00 00 00 0A 00 00 00 00 29 00 00 00 Sense Key: 0x6 Unit Attention, Segment 0 Sense Code: 0x29 Qual 0x00 (power on, reset, or bus device reset occurred) Fru 0x0 Sense flags: Blk 0 (not valid) cmd finished after 24.144s timeout 200s /usr/bin/cdrecord: fifo had 81 puts and 18 gets. /usr/bin/cdrecord: fifo was 0 times empty and 3 times full, min fill was 82%.
mkisofs ----------------------- 2.92% done, estimate finish Fri Sep 19 21:43:02 2003 5.85% done, estimate finish Fri Sep 19 21:43:02 2003 8.82% done, estimate finish Fri Sep 19 21:43:02 2003 11.70% done, estimate finish Fri Sep 19 21:43:02 2003 14.65% done, estimate finish Fri Sep 19 21:48:02 2003
