На флешку ничего не записывается.

[   1267.954349] hub 8-0:1.0: state 7 ports 5 chg 0000 evt 0020
[   1267.954357] ehci_hcd 0000:00:13.2: GetStatus port:5 status 001002 0  ACK POWER sig=se0 CSC
[   1267.954364] hub 8-0:1.0: port 5, status 0100, change 0001, 12 Mb/s
[   1267.954367] usb 8-5: USB disconnect, device number 2
[   1267.954368] usb 8-5: unregistering device
[   1267.954369] usb 8-5: unregistering interface 8-5:1.0
[   1267.955275] usb 8-5: usb_disable_device nuking all URBs
[   1268.061039] hub 8-0:1.0: debounce: port 5: total 100ms stable 100ms status 0x100
[   1270.704055] hub 8-0:1.0: hub_suspend
[   1270.704062] usb usb8: bus auto-suspend, wakeup 1
[   1270.704065] ehci_hcd 0000:00:13.2: suspend root hub
[   1271.241483] usb usb8: usb wakeup-resume
[   1271.241487] usb usb8: usb auto-resume
[   1271.241490] ehci_hcd 0000:00:13.2: resume root hub
[   1271.261043] hub 8-0:1.0: hub_resume
[   1271.261059] ehci_hcd 0000:00:13.2: GetStatus port:5 status 001803 0  ACK POWER sig=j CSC CONNECT
[   1271.261061] hub 8-0:1.0: port 5: status 0501 change 0001
[   1271.362079] hub 8-0:1.0: state 7 ports 5 chg 0020 evt 0000
[   1271.362089] hub 8-0:1.0: port 5, status 0501, change 0000, 480 Mb/s
[   1271.413120] ehci_hcd 0000:00:13.2: port 5 high speed
[   1271.413125] ehci_hcd 0000:00:13.2: GetStatus port:5 status 001005 0  ACK POWER sig=se0 PE CONNECT
[   1271.464058] usb 8-5: new high-speed USB device number 3 using ehci_hcd
[   1271.549063] ehci_hcd 0000:00:13.2: port 5 high speed
[   1271.549067] ehci_hcd 0000:00:13.2: GetStatus port:5 status 001005 0  ACK POWER sig=se0 PE CONNECT
[   1271.648605] usb 8-5: default language 0x0409
[   1271.652858] usb 8-5: udev 3, busnum 8, minor = 898
[   1271.652860] usb 8-5: New USB device found, idVendor=8564, idProduct=1000
[   1271.652862] usb 8-5: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[   1271.652864] usb 8-5: Product: Mass Storage Device
[   1271.652865] usb 8-5: Manufacturer: JetFlash
[   1271.652866] usb 8-5: SerialNumber: BX4AGJ4D
[   1271.652916] usb 8-5: usb_probe_device
[   1271.652919] usb 8-5: configuration #1 chosen from 1 choice
[   1271.653168] usb 8-5: adding 8-5:1.0 (config #1, interface 0)
[   1271.653200] usb-storage 8-5:1.0: usb_probe_interface
[   1271.653204] usb-storage 8-5:1.0: usb_probe_interface - got id
[   1271.653262] scsi12 : usb-storage 8-5:1.0
[   1272.655021] scsi 12:0:0:0: Direct-Access     JetFlash Transcend 8GB    8.01 PQ: 0 ANSI: 2
[   1272.655120] sd 12:0:0:0: Attached scsi generic sg2 type 0
[   1272.656627] sd 12:0:0:0: [sdb] 15635364 512-byte logical blocks: (8.00 GB/7.45 GiB)
[   1272.657090] sd 12:0:0:0: [sdb] Write Protect is on
[   1272.657094] sd 12:0:0:0: [sdb] Mode Sense: 03 00 00 00
[   1272.976191] sd 12:0:0:0: [sdb] Attached SCSI removable disk

[   1272.657090] sd 12:0:0:0: [sdb] Write Protect is on