Причины писка нового HDD

Что в S.M.A.R.T.?

=== START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED

General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 625) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 34) minutes. Conveyance self-test routine recommended polling time: ( 2) minutes. SCT capabilities: (0x103f) SCT Status supported. SCT Feature Control supported. SCT Data Table supported.

SMART Attributes Data Structure revision number: 10 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000f 120 093 006 Pre-fail Always - 237763361 3 Spin_Up_Time 0x0003 100 100 000 Pre-fail Always - 0 4 Start_Stop_Count 0x0032 085 085 020 Old_age Always - 15525 5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0 7 Seek_Error_Rate 0x000f 100 253 030 Pre-fail Always - 254662 9 Power_On_Hours 0x0032 100 100 000 Old_age Always - 67 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 085 085 020 Old_age Always - 15875 183 Unknown_Attribute 0x0032 100 100 000 Old_age Always - 0 184 Unknown_Attribute 0x0032 100 100 099 Old_age Always - 0 187 Reported_Uncorrect 0x0032 001 001 000 Old_age Always - 288 188 Unknown_Attribute 0x0032 100 099 000 Old_age Always - 19 189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0 190 Airflow_Temperature_Cel 0x0022 060 052 045 Old_age Always - 40 (Lifetime Min/Max 40/40) 194 Temperature_Celsius 0x0022 040 048 000 Old_age Always - 40 (0 24 0 0) 195 Hardware_ECC_Recovered 0x001a 076 063 000 Old_age Always - 237763361 197 Current_Pending_Sector 0x0012 100 099 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0010 100 099 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0 240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 42966852843482 241 Unknown_Attribute 0x0000 100 253 000 Old_age Offline - 32610207 242 Unknown_Attribute 0x0000 100 253 000 Old_age Offline - 747511243

SMART Error Log Version: 1 ATA Error Count: 323 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It «wraps» after 49.710 days.

Error 323 occurred at disk power-on lifetime: 48 hours (2 days + 0 hours) When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were: ER ST SC SN CL CH DH  — -- — -- — -- -- 40 51 00 8c dc c9 06 Error: UNC at LBA = 0x06c9dc8c = 113892492

Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name  — -- — -- — -- — -- ---------------- -------------------- 25 00 01 8c dc c9 e6 00 00:27:21.210 READ DMA EXT 25 00 01 8b dc c9 e6 00 00:27:21.209 READ DMA EXT 25 00 01 8a dc c9 e6 00 00:27:21.208 READ DMA EXT 25 00 01 89 dc c9 e6 00 00:27:21.208 READ DMA EXT 25 00 01 88 dc c9 e6 00 00:27:21.208 READ DMA EXT

Error 322 occurred at disk power-on lifetime: 48 hours (2 days + 0 hours) When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were: ER ST SC SN CL CH DH  — -- — -- — -- -- 40 51 00 8c dc c9 06 Error: UNC at LBA = 0x06c9dc8c = 113892492 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name  — -- — -- — -- — -- ---------------- -------------------- 25 00 00 2c cd c9 e6 00 00:27:18.121 READ DMA EXT 25 00 00 2c cc c9 e6 00 00:27:18.024 READ DMA EXT 35 00 01 2b cc c9 e6 00 00:27:18.020 WRITE DMA EXT 25 00 01 2b cc c9 e6 00 00:27:15.290 READ DMA EXT 25 00 01 2a cc c9 e6 00 00:27:15.289 READ DMA EXT

Error 321 occurred at disk power-on lifetime: 48 hours (2 days + 0 hours) When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were: ER ST SC SN CL CH DH  — -- — -- — -- -- 40 51 00 2b cc c9 06 Error: UNC at LBA = 0x06c9cc2b = 113888299

Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name  — -- — -- — -- — -- ---------------- -------------------- 25 00 01 2b cc c9 e6 00 00:27:15.290 READ DMA EXT 25 00 01 2a cc c9 e6 00 00:27:15.289 READ DMA EXT 25 00 01 29 cc c9 e6 00 00:27:15.289 READ DMA EXT 25 00 01 28 cc c9 e6 00 00:27:15.288 READ DMA EXT 25 00 01 27 cc c9 e6 00 00:27:15.288 READ DMA EXT Error 320 occurred at disk power-on lifetime: 48 hours (2 days + 0 hours) When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were: ER ST SC SN CL CH DH  — -- — -- — -- -- 40 51 00 2b cc c9 06 Error: UNC at LBA = 0x06c9cc2b = 113888299

Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name  — -- — -- — -- — -- ---------------- -------------------- 25 00 00 e4 f0 c8 e6 00 00:27:11.994 READ DMA EXT 25 00 00 e4 ef c8 e6 00 00:27:11.985 READ DMA EXT 25 00 00 e4 ee c8 e6 00 00:27:11.983 READ DMA EXT 25 00 00 e4 ed c8 e6 00 00:27:11.982 READ DMA EXT 25 00 00 e4 ec c8 e6 00 00:27:11.980 READ DMA EXT

Error 319 occurred at disk power-on lifetime: 48 hours (2 days + 0 hours) When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were: ER ST SC SN CL CH DH  — -- — -- — -- -- 40 51 00 e3 81 c8 06 Error: UNC at LBA = 0x06c881e3 = 113803747

Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name  — -- — -- — -- — -- ---------------- -------------------- 25 00 01 e3 81 c8 e6 00 00:27:08.678 READ DMA EXT 25 00 01 e2 81 c8 e6 00 00:27:08.677 READ DMA EXT 25 00 01 e1 81 c8 e6 00 00:27:08.676 READ DMA EXT 25 00 01 e0 81 c8 e6 00 00:27:08.676 READ DMA EXT 25 00 01 df 81 c8 e6 00 00:27:08.676 READ DMA EXT

SMART Self-test log structure revision number 1 No self-tests have been logged. [To run self-tests, use: smartctl -t]

SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.

Жесткий - SATA-3 160Gb Seagate 7200 Barracuda 7200.12

Я как раз такой хотел брать.

http://linux.org.ru/wiki/en/User:AITap/Покажите_логи#a_.D0.97.D0.B0.D0.B3.D1....

Жесткий - SATA-3 160Gb Seagate 7200 Barracuda 7200.12

Я как раз такой хотел брать.

Когда ? :-) Их, разве, делают ещё ?

Насчёт производства не знаю, но пока продают

Исправлюсь,http://paste.org.ru/?u6w57y

некто не может нечего сказать по счет отчета смарта?

Хмм у меня с Seagate FreeAgentGo 250gb таже проблема, только время работы до такого состояния 2-3 суток... потом винт теряется под тихие звуки пип-пип-пип-пип. Помогает только переподключение. Я не парюсь особо т.к. винт usb'шный.

(* вытаскивание из кармана и подключение непосредственно к sata ничего не даёт)...