Вообщем решил заняться этим делом, ниже будут команды которые я вводил и сама ошибка
root@kirin:/home/kiri# iwconfig
enp2s0 no wireless extensions.
lo no wireless extensions.
wlan0 IEEE 802.11abgn ESSID:"TP-LINK_8538"
Mode:Managed Frequency:2.427 GHz Access Point: EC:08:6B:6F:85:38
Bit Rate=1 Mb/s Tx-Power=20 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:on
Link Quality=70/70 Signal level=-32 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:90 Missed beacon:0
root@kirin:/home/kiri# airmon-ng start wlan0
Found 3 processes that could cause trouble.
If airodump-ng, aireplay-ng or airtun-ng stops working after
a short period of time, you may want to run 'airmon-ng check kill'
PID Name
19857 wpa_supplicant
21659 NetworkManager
21698 dhclient
PHY Interface Driver Chipset
phy0 wlan0 ath10k_pci Qualcomm Atheros Device 0042 (rev 30)
(mac80211 monitor mode vif enabled for [phy0]wlan0 on [phy0]wlan0mon)
(mac80211 station mode vif disabled for [phy0]wlan0)
root@kirin:/home/kiri# airmon-ng check kill
Killing these processes:
PID Name
19857 wpa_supplicant
root@kirin:/home/kiri# iwconfig
enp2s0 no wireless extensions.
lo no wireless extensions.
wlan0mon IEEE 802.11abgn Mode:Monitor Frequency:2.457 GHz Tx-Power=0 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Power Management:on
root@kirin:/home/kiri# wash -i wlan0mon
Wash v1.5.3 WiFi Protected Setup Scan Tool
Copyright (c) 2011, Tactical Network Solutions, Craig Heffner
mod by t6_x<t6_x@hotmail.com>, DataHead, Soxrok2212, Wiire, AAnarchYY & rofl0r
BSSID Ch dBm WPS Lck ESSID
--------------------------------------------------------------------------------
E4:3E:D7:D3:FF:0E 1 -79 1.0 No MiFibra-FF0C
98:97:D1:7F:A0:34 1 -75 1.0 No MOVISTAR_A033
D4:7B:B0:92:12:0D 1 -86 1.0 No MOVISTAR_120C
E0:41:36:1F:88:0E 1 -86 1.0 No AMADEO
EC:08:6B:6F:85:38 4 -33 1.0 No TP-LINK_8538
^C
тем временем в другом окне
root@kirin:/home/kiri# aireplay-ng -1 5 -a EC:08:6B:6F:85:38 wlan0mon
No source MAC (-h) specified. Using the device MAC (AC:E0:10:81:D4:B5)
20:51:27 Waiting for beacon frame (BSSID: EC:08:6B:6F:85:38) on channel 4
20:51:28 Sending Authentication Request (Open System)
20:51:30 Sending Authentication Request (Open System)
20:51:32 Sending Authentication Request (Open System)
20:51:34 Sending Authentication Request (Open System)
20:51:36 Sending Authentication Request (Open System)
20:51:38 Sending Authentication Request (Open System)
20:51:40 Sending Authentication Request (Open System)
20:51:42 Sending Authentication Request (Open System)
20:51:44 Sending Authentication Request (Open System)
20:51:46 Sending Authentication Request (Open System)
20:51:48 Sending Authentication Request (Open System)
20:51:50 Sending Authentication Request (Open System)
20:51:52 Sending Authentication Request (Open System)
20:51:54 Sending Authentication Request (Open System)
20:51:56 Sending Authentication Request (Open System)
20:51:58 Sending Authentication Request (Open System)
Attack was unsuccessful. Possible reasons:
* Perhaps MAC address filtering is enabled.
* Check that the BSSID (-a option) is correct.
* Try to change the number of packets (-o option).
* The driver/card doesn't support injection.
* This attack sometimes fails against some APs.
* The card is not on the same channel as the AP.
* You're too far from the AP. Get closer, or lower
the transmit rate.
а в первом
[+] Waiting for beacon from EC:08:6B:6F:85:38
[+] Switching wlan0mon to channel 4
[+] Associated with EC:08:6B:6F:85:38 (ESSID: TP-LINK_8538)
[+] Starting Cracking Session. Pin count: 0, Max pin attempts: 11000
[+] Trying pin 12345670
[+] Sending EAPOL START request
[!] WARNING: Receive timeout occurred
[+] Sending EAPOL START request
[!] WARNING: Receive timeout occurred
[+] Sending EAPOL START request
и так постоянно, пробовал reaver запускать с командой --no-nacks и т.д, ничего не помогает, какие идейки есть?