suspen to ram не суспендит

1) когда же вы научитесь сами смотреть в логи....
2) попробуй на диск усыплять

Сотрел я в лог, но ничего не понял, он заснул и проснулся. Непонятно, что там ошибка и что нет.


ACPI: Preparing to enter system sleep state S3
Disabling non-boot CPUs ...
Unmapping cpu 1 from all nodes
Unmapping cpu 1 from all nodes
CPU 1 is now offline
SMP alternatives: switching to UP code
CPU0 attaching NULL sched-domain.
CPU1 attaching NULL sched-domain.
CPU0 attaching NULL sched-domain.
CPU1 is down
Extended CMOS year: 2000
 hwsleep-0315 [00] enter_sleep_state     : Entering sleep state [S3]
x86 PAT enabled: cpu 0, old 0x7040600070406, new 0x7010600070106
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
evxfevnt-0079 [00] enable                : System is already in ACPI mode
Back to C!
Extended CMOS year: 2000
pci 0000:00:00.0: restoring config space at offset 0xf (was 0x0, writing 0xff)
pci 0000:00:00.1: restoring config space at offset 0xf (was 0xffffffff, writing 0x0)
pci 0000:00:00.1: restoring config space at offset 0xe (was 0xffffffff, writing 0x0)
pci 0000:00:00.1: restoring config space at offset 0xd (was 0xffffffff, writing 0x0)
pci 0000:00:00.1: restoring config space at offset 0xc (was 0xffffffff, writing 0x0)
pci 0000:00:00.1: restoring config space at offset 0xb (was 0xffffffff, writing 0x81c01043)
pci 0000:00:00.1: restoring config space at offset 0xa (was 0xffffffff, writing 0x0)
pci 0000:00:00.1: restoring config space at offset 0x9 (was 0xffffffff, writing 0x0)
pci 0000:00:00.1: restoring config space at offset 0x8 (was 0xffffffff, writing 0x0)
pci 0000:00:00.1: restoring config space at offset 0x7 (was 0xffffffff, writing 0x0)
pci 0000:00:00.1: restoring config space at offset 0x6 (was 0xffffffff, writing 0x0)
pci 0000:00:00.1: restoring config space at offset 0x5 (was 0xffffffff, writing 0x0)
pci 0000:00:00.1: restoring config space at offset 0x4 (was 0xffffffff, writing 0x0)
pci 0000:00:00.1: restoring config space at offset 0x3 (was 0xffffffff, writing 0x800000)
pci 0000:00:00.1: restoring config space at offset 0x2 (was 0xffffffff, writing 0x50000a2)
pci 0000:00:00.1: restoring config space at offset 0x1 (was 0xffffffff, writing 0x40200100)
pci 0000:00:00.1: restoring config space at offset 0x0 (was 0xffffffff, writing 0x2fa10de)
pci 0000:00:00.3: restoring config space at offset 0xf (was 0x0, writing 0xff)
pci 0000:00:00.4: restoring config space at offset 0xf (was 0x0, writing 0xff)
pci 0000:00:00.5: restoring config space at offset 0xf (was 0x0, writing 0xff)
pci 0000:00:00.6: restoring config space at offset 0x1 (was 0x200100, writing 0x200102)
pcieport-driver 0000:00:02.0: restoring config space at offset 0x1 (was 0x100007, writing 0x100407)
pcieport-driver 0000:00:03.0: restoring config space at offset 0x1 (was 0x100007, writing 0x100407)
pcieport-driver 0000:00:04.0: restoring config space at offset 0x7 (was 0xb1b1, writing 0x2000b1b1)
pcieport-driver 0000:00:04.0: restoring config space at offset 0x1 (was 0x100007, writing 0x100407)
pci 0000:00:09.0: restoring config space at offset 0xf (was 0x0, writing 0xff)
Enabling non-boot CPUs ...
SMP alternatives: switching to SMP code
Booting processor 1/1 ip 6000
Initializing CPU#1
Mapping cpu 1 to node 0
Calibrating delay using timer specific routine.. 4409.30 BogoMIPS (lpj=8818603)
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line)
CPU: L2 Cache: 512K (64 bytes/line)
CPU 1(2) -> Core 1
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#1.
x86 PAT enabled: cpu 1, old 0x7040600070406, new 0x7010600070106
CPU1: AMD Athlon(tm) 64 X2 Dual Core Processor 4200+ stepping 01
CPU0 attaching NULL sched-domain.
Switched to high resolution mode on CPU 1
CPU0 attaching sched-domain:
 domain 0: span 0-1 level CPU
  groups: 0 1
  domain 1: span 0-1 level NODE
   groups: 0-1
CPU1 attaching sched-domain:
 domain 0: span 0-1 level CPU
  groups: 1 0
  domain 1: span 0-1 level NODE
   groups: 0-1
CPU1 is up
ACPI: Waking up from system sleep state S3
ACPI: Unable to turn cooling device [f4851658] 'off'
pcieport-driver 0000:00:02.0: setting latency timer to 64
pcieport-driver 0000:00:03.0: setting latency timer to 64
pcieport-driver 0000:00:04.0: setting latency timer to 64
ohci_hcd 0000:00:0b.0: wake-up capability disabled by ACPI
ohci_hcd 0000:00:0b.0: PME# disabled
ohci_hcd 0000:00:0b.0: wake-up capability disabled by ACPI
ohci_hcd 0000:00:0b.0: PME# disabled
ohci_hcd 0000:00:0b.0: PCI INT A -> Link[APCF] -> GSI 20 (level, low) -> IRQ 20
ohci_hcd 0000:00:0b.0: setting latency timer to 64
usb usb2: root hub lost power or was reset
ehci_hcd 0000:00:0b.1: PCI INT B -> Link[APCL] -> GSI 21 (level, low) -> IRQ 21
ehci_hcd 0000:00:0b.1: setting latency timer to 64
pata_amd 0000:00:0d.0: setting latency timer to 64
ata5: port disabled. ignoring.
sata_nv 0000:00:0e.0: restoring config space at offset 0x1 (was 0xb00000, writing 0xb00007)
sata_nv 0000:00:0e.0: PCI INT A -> Link[APSI] -> GSI 23 (level, low) -> IRQ 23
sata_nv 0000:00:0e.0: setting latency timer to 64
sata_nv 0000:00:0f.0: restoring config space at offset 0x1 (was 0xb00000, writing 0xb00007)
sata_nv 0000:00:0f.0: PCI INT A -> Link[APSJ] -> GSI 22 (level, low) -> IRQ 22
sata_nv 0000:00:0f.0: setting latency timer to 64
pci 0000:00:10.0: setting latency timer to 64
HDA Intel 0000:00:10.1: restoring config space at offset 0x1 (was 0xb00006, writing 0xb00002)
HDA Intel 0000:00:10.1: PCI INT B -> Link[AAZA] -> GSI 22 (level, low) -> IRQ 22
HDA Intel 0000:00:10.1: setting latency timer to 64
forcedeth 0000:00:14.0: restoring config space at offset 0xf (was 0x14010100, writing 0x1401010b)
forcedeth 0000:00:14.0: restoring config space at offset 0x5 (was 0x1, writing 0xc801)
forcedeth 0000:00:14.0: restoring config space at offset 0x4 (was 0x0, writing 0xfe02b000)
forcedeth 0000:00:14.0: restoring config space at offset 0x1 (was 0xb00000, writing 0xb00007)
forcedeth 0000:00:14.0: wake-up capability disabled by ACPI
forcedeth 0000:00:14.0: PME# disabled
serial 00:08: activated
parport_pc 00:09: activated
sd 0:0:0:0: [sda] Starting disk
ata2: SATA link down (SStatus 0 SControl 300)
ata3: SATA link down (SStatus 0 SControl 300)
ata1: SATA link up 3.0 Gbps (SStatus 123 SControl 300)
ata4: SATA link up 1.5 Gbps (SStatus 113 SControl 300)
ata4.00: ACPI cmd ef/03:46:00:00:00:a0 filtered out
ata1.00: ACPI cmd ef/03:46:00:00:00:a0 filtered out
ata4.00: configured for UDMA/66
ata1.00: configured for UDMA/133
sd 0:0:0:0: [sda] 625142448 512-byte hardware sectors: (320GB/298GiB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00
sd 0:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA
usb 2-1: reset low speed USB device using ohci_hcd and address 2
Restarting tasks ... done.

пилите pm-utils, Шура, они - золотые...

Ну а что в dmesg и /var/log/messages?

И вообще, на tuxonice стоит забить, есть же swsusp.

>>pm-utils

+много. Зачем нужны остальные костыли, непонятно.

Я написал в начале. Я и pm-utils пробовал. Тот же самый эффект.

>Ну а что в dmesg и /var/log/messages?

Я выше привел выхлоп dmesg, в messages ничего нет, все тож самое.

у мя похожая дрянь была из-за воткнутой usb мыши


как совет, попробуй перед саспендом выгрузить все возможные модули: обычная сеть, вафля, usb, может ещё что найдёшь