В декабре прошлого года купил два диска «Toshiba PC P300 1TB», собрал из них RAID-1. Эксплуатировал не особо сильно. Домашний ПК, на котором я в основном интернеты читаю и разрабатываю. На две недели уезжал в отпуск, полностью обесточил ЭВМ, вынул шнур питания сетевого фильтра из розетки. Сейчас включил и слышу это на одном из дисков.
Диск определяется, система работает но подлагивает из-за данной проблемы. Я решил отключить (физически) щёлкающую железяку. Чего ещё сделать/посмотреть?
Наверное лучше не жмотиться и купить новый диск, а этот раздолбать (есть конфиденциальные данные, не всё зашифровано)?
smartctl 6.5 2016-05-07 r4318 [x86_64-linux-4.4.14] (local build)
Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Device Model: TOSHIBA HDWD110
Serial Number: 68KSUDMFS
LU WWN Device Id: 5 000039 fd6f51a6c
Firmware Version: MS2OA8R0
User Capacity: 1,000,204,886,016 bytes [1.00 TB]
Sector Sizes: 512 bytes logical, 4096 bytes physical
Rotation Rate: 7200 rpm
Form Factor: 3.5 inches
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 3.0, 6.0 Gb/s (current: 3.0 Gb/s)
Local Time is: Sat Jul 13 21:23:10 2019 YEKT
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x80) Offline data collection activity
was never started.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 121) The previous self-test completed having
the read element of the test failed.
Total time to complete Offline
data collection: ( 7604) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 127) minutes.
SCT capabilities: (0x003d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000b 100 100 016 Pre-fail Always - 0
2 Throughput_Performance 0x0005 100 100 054 Pre-fail Offline - 0
3 Spin_Up_Time 0x0007 124 124 024 Pre-fail Always - 185 (Average 185)
4 Start_Stop_Count 0x0012 100 100 000 Old_age Always - 268
5 Reallocated_Sector_Ct 0x0033 059 059 005 Pre-fail Always - 833
7 Seek_Error_Rate 0x000b 100 100 067 Pre-fail Always - 0
8 Seek_Time_Performance 0x0005 100 100 020 Pre-fail Offline - 0
9 Power_On_Hours 0x0012 100 100 000 Old_age Always - 1859
10 Spin_Retry_Count 0x0013 100 100 060 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 265
192 Power-Off_Retract_Count 0x0032 099 099 000 Old_age Always - 2019
193 Load_Cycle_Count 0x0012 099 099 000 Old_age Always - 2019
194 Temperature_Celsius 0x0002 142 142 000 Old_age Always - 42 (Min/Max 22/43)
196 Reallocated_Event_Count 0x0032 016 016 000 Old_age Always - 1699
197 Current_Pending_Sector 0x0022 081 081 000 Old_age Always - 544
198 Offline_Uncorrectable 0x0008 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x000a 200 200 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 6 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 6 occurred at disk power-on lifetime: 1846 hours (76 days + 22 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 98 2f d6 03 Error: UNC at LBA = 0x03d62f98 = 64368536
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 08 d0 98 2f d6 40 00 1d+17:53:16.206 READ FPDMA QUEUED
60 08 c8 90 2f d6 40 00 1d+17:53:16.163 READ FPDMA QUEUED
61 c0 c0 f0 26 c8 40 00 1d+17:53:16.161 WRITE FPDMA QUEUED
ea 00 00 00 00 00 a0 00 1d+17:53:16.144 FLUSH CACHE EXT
61 05 b0 88 87 6c 40 00 1d+17:53:16.144 WRITE FPDMA QUEUED
Error 5 occurred at disk power-on lifetime: 1846 hours (76 days + 22 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 98 2f d6 03 Error: UNC at LBA = 0x03d62f98 = 64368536
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 10 e0 90 2f d6 40 00 1d+17:53:12.130 READ FPDMA QUEUED
ea 00 00 00 00 00 a0 00 1d+17:53:12.049 FLUSH CACHE EXT
61 10 d0 a0 f5 79 40 00 1d+17:53:12.049 WRITE FPDMA QUEUED
61 08 c8 90 91 c6 40 00 1d+17:53:11.980 WRITE FPDMA QUEUED
61 08 c0 88 91 c6 40 00 1d+17:53:11.945 WRITE FPDMA QUEUED
Error 4 occurred at disk power-on lifetime: 1845 hours (76 days + 21 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 b8 4c d6 03 Error: UNC at LBA = 0x03d64cb8 = 64375992
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 08 48 b8 4c d6 40 00 1d+16:43:18.166 READ FPDMA QUEUED
60 08 40 b0 4c d6 40 00 1d+16:43:18.166 READ FPDMA QUEUED
60 08 38 a8 4c d6 40 00 1d+16:43:18.166 READ FPDMA QUEUED
60 08 30 a0 4c d6 40 00 1d+16:43:18.141 READ FPDMA QUEUED
ea 00 00 00 00 00 a0 00 1d+16:43:18.133 FLUSH CACHE EXT
Error 3 occurred at disk power-on lifetime: 1845 hours (76 days + 21 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 b8 4c d6 03 Error: UNC at LBA = 0x03d64cb8 = 64375992
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 20 88 a0 4c d6 40 00 1d+16:43:14.157 READ FPDMA QUEUED
60 20 80 80 4c d6 40 00 1d+16:43:14.152 READ FPDMA QUEUED
60 20 78 d8 b6 d0 40 00 1d+16:43:14.146 READ FPDMA QUEUED
60 10 70 b8 b6 d0 40 00 1d+16:43:14.146 READ FPDMA QUEUED
60 10 68 c8 b6 d0 40 00 1d+16:43:14.146 READ FPDMA QUEUED
Error 2 occurred at disk power-on lifetime: 1845 hours (76 days + 21 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 98 7e d6 03 Error: UNC at LBA = 0x03d67e98 = 64388760
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 08 c8 98 7e d6 40 00 1d+16:41:25.262 READ FPDMA QUEUED
60 08 c0 90 7e d6 40 00 1d+16:41:25.237 READ FPDMA QUEUED
ea 00 00 00 00 00 a0 00 1d+16:41:25.229 FLUSH CACHE EXT
61 08 b0 80 87 6c 40 00 1d+16:41:25.229 WRITE FPDMA QUEUED
ea 00 00 00 00 00 a0 00 1d+16:41:25.229 FLUSH CACHE EXT
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed: read failure 90% 1859 1135522584
# 2 Extended offline Aborted by host 90% 1859 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.