Помогите установить WIFI-адаптер ASUS WL-167G v3 USB

root@bt:~# ifconfig -a
eth0      Link encap:Ethernet  HWaddr 00:90:f5:fd:4c:37  
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)
          Interrupt:45 

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:472 errors:0 dropped:0 overruns:0 frame:0
          TX packets:472 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:66357 (66.3 KB)  TX bytes:66357 (66.3 KB)

mon0      Link encap:UNSPEC  HWaddr E0-B9-A5-B3-31-05-30-30-00-00-00-00-00-00-00-00  
          UP BROADCAST NOTRAILERS RUNNING PROMISC ALLMULTI  MTU:1500  Metric:1
          RX packets:2883 errors:0 dropped:168 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:721146 (721.1 KB)  TX bytes:0 (0.0 B)

wlan0     Link encap:Ethernet  HWaddr e0:b9:a5:b3:31:05  
          inet addr:192.168.1.66  Bcast:192.168.1.255  Mask:255.255.255.0
          inet6 addr: fe80::e2b9:a5ff:feb3:3105/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:3370 errors:0 dropped:0 overruns:0 frame:0
          TX packets:3127 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:3381719 (3.3 MB)  TX bytes:748527 (748.5 KB)

wlan1     Link encap:Ethernet  HWaddr f4:6d:04:8b:74:81  
          BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)

[ 3092.687175] cfg80211: Updating information on frequency 2452 MHz for a 20 MHz width channel with regulatory rule:
[ 3092.687187] cfg80211: 2402000 KHz - 2482000 KHz @  KHz), (N/A mBi, 2000 mBm)
[ 3092.687197] cfg80211: Updating information on frequency 2457 MHz for a 20 MHz width channel with regulatory rule:
[ 3092.687209] cfg80211: 2402000 KHz - 2482000 KHz @  KHz), (N/A mBi, 2000 mBm)
[ 3092.687219] cfg80211: Updating information on frequency 2462 MHz for a 20 MHz width channel with regulatory rule:
[ 3092.687231] cfg80211: 2402000 KHz - 2482000 KHz @  KHz), (N/A mBi, 2000 mBm)
[ 3092.687241] cfg80211: Updating information on frequency 2467 MHz for a 20 MHz width channel with regulatory rule:
[ 3092.687253] cfg80211: 2402000 KHz - 2482000 KHz @  KHz), (N/A mBi, 2000 mBm)
[ 3092.687263] cfg80211: Updating information on frequency 2472 MHz for a 20 MHz width channel with regulatory rule:
[ 3092.687275] cfg80211: 2402000 KHz - 2482000 KHz @  KHz), (N/A mBi, 2000 mBm)
[ 3092.687284] cfg80211: Disabling freq 2484 MHz
[ 3092.687299] cfg80211: Regulatory domain changed to country: RU
[ 3092.687309] cfg80211:     (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 3092.687321] cfg80211:     (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[ 3092.946672] wlan0: IPv6 duplicate address fe80::e2b9:a5ff:feb3:3105 detected!
[ 3781.005899] device mon0 entered promiscuous mode
[ 4489.188266] r8712u: Loading firmware from "rtlwifi/rtl8712u.bin"
[ 4489.868637] r8712u: 1 RCR=0x153f00e
[ 4489.869383] r8712u: 2 RCR=0x553f00e
[ 4489.977249] ADDRCONF(NETDEV_UP): wlan1: link is not ready

Found 5 processes that could cause trouble.
If airodump-ng, aireplay-ng or airtun-ng stops working after
a short period of time, you may want to kill (some of) them!

PID	Name
1390	dhclient3
1475	dhclient3
3591	wpa_supplicant
3600	dhclient
3618	dhclient
Process with PID 1475 (dhclient3) is running on interface wlan0
Process with PID 3591 (wpa_supplicant) is running on interface wlan0
Process with PID 3618 (dhclient) is running on interface wlan0


Interface	Chipset		Driver

wlan0		Unknown 	rtl8192ce - [phy0]
mon0		Unknown 	rtl8192ce - [phy0]

root@bt:~# ifconfig wlan1 down
root@bt:~# airodump-ng wlan1
ioctl(SIOCSIWMODE) failed: Invalid argument

ARP linktype is set to 1 (Ethernet) - expected ARPHRD_IEEE80211,
ARPHRD_IEEE80211_FULL or ARPHRD_IEEE80211_PRISM instead.  Make
sure RFMON is enabled: run 'airmon-ng start wlan1 <#>'
Sysfs injection support was not found either.

ifconfig wlan1 up
iwconfig wlan1 mode monitor
airodump-ng wlan1

root@bt:~# iwconfig wlan1 mode monitor
Error for wireless request "Set Mode" (8B06) :
    SET failed on device wlan1 ; Invalid argument.