Пытаюсь заставить работать сабж в Debian Squeeze, ядро 32. Всё делаю по инструкции с http://wiki.debian.org/bcm43xx#b43-b43legacy-squeeze
Всё ставится нормально, модуль загружается (lsmod подтверждает).
К wi-fi подключиться не получается: не выдается ip-адрес через dhcp.
На точке WEP, подключиться пытался как через wicd, так и вручную (dhclient wlan1 -v, не забыв iwconfig wlan1 essid ... и так далее).
wlan1 IEEE 802.11bg ESSID:"linksys"
Mode:Managed Frequency:2.437 GHz Access Point: макточки
Bit Rate=1 Mb/s Tx-Power=20 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Encryption key:ключ
Power Management:off
Link Quality=70/70 Signal level=5 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
# dhclient wlan1 -v
Internet Systems Consortium DHCP Client 4.1.1-P1
Copyright 2004-2010 Internet Systems Consortium.
All rights reserved.
For info, please visit https://www.isc.org/software/dhcp/
Listening on LPF/wlan1/мак
Sending on LPF/wlan1/мак
Sending on Socket/fallback
DHCPDISCOVER on wlan1 to 255.255.255.255 port 67 interval 6
DHCPDISCOVER on wlan1 to 255.255.255.255 port 67 interval 6
DHCPDISCOVER on wlan1 to 255.255.255.255 port 67 interval 10
DHCPDISCOVER on wlan1 to 255.255.255.255 port 67 interval 12
DHCPDISCOVER on wlan1 to 255.255.255.255 port 67 interval 14
DHCPDISCOVER on wlan1 to 255.255.255.255 port 67 interval 13
No DHCPOFFERS received.
No working leases in persistent database - sleeping.
Linux breton 2.6.32-5-686 #1 SMP Sat Jul 24 02:27:10 UTC 2010 i686 GNU/Linux
dmesg
[ 2614.050388] cfg80211: Calling CRDA to update world regulatory domain
[ 2614.077217] Compat-wireless backport release: compat-wireless-2010-08-03-1-g3672499
[ 2614.077221] Backport based on linux-next.git next-20100806
[ 2614.083207] b43-pci-bridge 0000:0c:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 2614.083229] b43-pci-bridge 0000:0c:00.0: setting latency timer to 64
[ 2614.100729] ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x16, vendor 0x4243)
[ 2614.100747] ssb: Core 1 found: IEEE 802.11 (cc 0x812, rev 0x0F, vendor 0x4243)
[ 2614.100764] ssb: Core 2 found: PCMCIA (cc 0x80D, rev 0x0A, vendor 0x4243)
[ 2614.100782] ssb: Core 3 found: PCI-E (cc 0x820, rev 0x09, vendor 0x4243)
[ 2614.148548] ssb: Sonics Silicon Backplane found on PCI device 0000:0c:00.0
[ 2614.156432] b43-phy0: Broadcom 4312 WLAN found (core revision 15)
[ 2614.228739] phy0: Selected rate control algorithm 'minstrel'
[ 2614.229566] Registered led device: b43-phy0::tx
[ 2614.229584] Registered led device: b43-phy0::rx
[ 2614.229601] Registered led device: b43-phy0::radio
[ 2614.229661] Broadcom 43xx driver loaded [ Features: PMNLS, Firmware-ID: FW13 ]
[ 2614.252195] udev: renamed network interface wlan0 to wlan1
[ 2680.652315] b43-phy0: Loading firmware version 478.104 (2008-07-01 00:50:23)
[ 2686.172555] b43-phy0 ERROR: Fatal DMA error: 0x00000400, 0x00000000, 0x00000000, 0x00000000, 0x00000000, 0x00000000
[ 2686.172561] b43-phy0 ERROR: This device does not support DMA on your system. It will now be switched to PIO.
[ 2686.172564] b43-phy0: Controller RESET (DMA error) ...
[ 2686.404490] b43-phy0: Loading firmware version 478.104 (2008-07-01 00:50:23)
[ 2691.917254] b43-phy0: Controller restarted
[ 2691.917830] ADDRCONF(NETDEV_UP): wlan1: link is not ready
[ 2693.212493] wlan1: authenticate with макточки (try 1)
[ 2693.214951] wlan1: authenticated
[ 2693.214971] wlan1: associate with макточки (try 1)
[ 2693.219568] wlan1: RX AssocResp from макточки (capab=0x431 status=0 aid=2)
[ 2693.219571] wlan1: associated
[ 2693.220643] ADDRCONF(NETDEV_CHANGE): wlan1: link becomes ready
[ 2703.384208] wlan1: no IPv6 routers present
[ 2739.500273] No probe response from AP макточки after 500ms, disconnecting.
[ 2739.520479] cfg80211: Calling CRDA to update world regulatory domain
Что не так? как можно заставить работать?
Ещё пытался завести через http://wiki.debian.org/wl#Squeeze , но при попытке подгрузить модуль wl произошла ошибка с выхлопом в dmesg
[ 2309.511201] wl: disagrees about version of symbol lib80211_get_crypto_ops
[ 2309.511206] wl: Unknown symbol lib80211_get_crypto_ops
Попытка подгрузить руками lib80211 ни к чему не привела.
// пока не пробовал руками поставить последние драйвера производителя и ndiswrapper, но это совсем какое-то извращение.
// чуть-чуть ключевых слов: dell vostro 1015